Setup.exe prompt Shows an Upgrade to the Same Version that FIMS is Currently on Instead of New Version

When upgrading using the setup.exe the prompt shows an upgrade from for example from 14.44 to 14.44 rather than 14.44 to 14.50 as expected if you are upgrading FIMS to a new version.
This has been resolved in version 14.60



 

Steps to Duplicate

1. On the FIMS server, launch the 14.50 setup.exe

2. Follow the steps documented in the Installation Instructions for 14.50:

https://www.blackbaud.com/files/support/guides/microedge/fims/fims_upgradeguide.pdf

3.  When getting to step 14 in the documentation, you will see that the message reads "You are converting from version 14.44 to 14.44" rather than the expected message, "You are converting from 14.44 to 14.50"

4. Click to proceed past step 14 and complete all steps in the document to step 19
5. Log into FIMS to check the version and note that it still reads 14.44 as the current version and not 14.50.

Environment

 FIMS

Was this article helpful?


Thanks for your feedback! Did this solve your issue?

Comments (optional):


Thanks for your feedback!
We're glad it was helpful but sorry it didn’t solve your issue. If you need assistance, click Chat with Support below.
We’re sorry to hear that. Please tell us why.

 I don't like how this works.

 The answer is confusing.

 The answer didn't match what I was searching for.

Additional Comments (optional):


Thanks for your feedback! If you need assistance, click Chat with Support below.
Thanks for your feedback. Help us make our products even better by sharing details in our Idea Banks or our online Community.
Thanks for letting us know. We'll work on clarifying the information in the article. If you need assistance, click Chat with Support below.
Thanks for letting us know. We'll work on updating the search engine to return more relevant results.