In order for Districting information to sync to Luminate CRM, Districting must first be enabled in Luminate CRM.

You can enable the use of districting in your instance by doing the following: 
  1. Go to Setup -> App Setup -> Develop -> Custom Settings. 
  2. Click Manage next to Luminate CRM Settings. 
  3. Click Edit. 
  4. In the Enable Districting field, enter "USE_DISTRICTING." 
  5. Click Save. 
Once this is done, Districting should be updated for records whose Addresses have been Standardized and Normalized.

Under the Address Information section of the Contact Record, there are the fields Address Standardization Status and Normalization Status.  If Districting is enabled after Address Standardization Status is set to Standardization Pending or Normalization Status is set to Normalization Needed, the districting information will not sync down.  If you change them, the districting information should sync down after the Address Standardization Task runs.

If there are several records that need districting information, they can be updated in bulk using the Data Loader.