Error: Invalid Column name 'ID' - when running validation on the Blackbaud Data Warehouse

When running validation on the Blackbaud Data Warehouse, the error, Invalid Column name 'ID', occurs along with several exceptions. This in turn causes the data warehouse reconciliation report to be blank since a successful validation is necessary in order for this report to be populated.
Download and install the latest patch which contains all fixes from previous patches. If you are running an older version, download and install the latest version and then the patch. 

Steps to Duplicate

1. Go to Administration\Administration\Data warehouses\Blackbaud Data Warehouse, click to open the Blackbaud Data Warehouse
2. Go to the Reconciliation report tab and notice that the report is empty after running it and running a full ETL reset and refresh. 
3.  Attempt to do the last step needed in order to get the report to populate which is to run validation on the Blackbaud Data Warehouse. Click on the Validate link on the left hand side under Validation.
4. See Status of Did not finish, and see status message of Invalid column name of 'ID' as well as 11 exceptions.

 

Environment

 Blackbaud CRM
 4.0
 4.0
 Service Pack 9
 4.0.141.18

Was this article helpful?