"Updating" stuck on page when attempting to remove part

When attempting to remove a custom part via a "Cut" in design mode in BBIS. The part goes to "Updating" and gets stuck.
This occurred because the part was using the out-of-box "txtUsername" validation control.  Doing so and placing this custom part on another page that also contains a form that uses this validation control will results in a scenario where the custom part interferes with the postback and cause the symptom described in this Knowledgebase article.  To avoid this problem, create a custom validation group control. 

Steps to Duplicate

1. Build and deploy a custom part.
2. Add the Custom part to page.
3. Attempt Cut the part or any other part from the page.

Environment

 Blackbaud Infinity SDK
 4.0

Was this article helpful?


Thanks for your feedback! Did this solve your issue?

Comments (optional):


Thanks for your feedback!
We're glad it was helpful but sorry it didn’t solve your issue. If you need assistance, click Chat with Support below.
We’re sorry to hear that. Please tell us why.

 I don't like how this works.

 The answer is confusing.

 The answer didn't match what I was searching for.

Additional Comments (optional):


Thanks for your feedback! If you need assistance, click Chat with Support below.
Thanks for your feedback. Help us make our products even better by sharing details in our Idea Banks or our online Community.
Thanks for letting us know. We'll work on clarifying the information in the article. If you need assistance, click Chat with Support below.
Thanks for letting us know. We'll work on updating the search engine to return more relevant results.